Can I simply pull out and replace a Kenwood car stereo with another?
Sunday, December 12th, 2010 at
1:07 pm
Question by jpg: Can I simply pull out and replace a Kenwood car stereo with another?
I have an after market Kenwood CD player in my 2001 Honda CRV installed by Best Buy. It doesn’t work right, so I wanna replace it with a new one. Can I simply pull it out and put in the new one without any new wiring harness or anything? I mean, can I do it myself in 15 minutes or less, or is it more involved than I think it is?
Best answer:
Answer by Metallman56
unless you bought anther Kenwood, then you would have to do a wiring harness.
good luck
Give your answer to this question below!
Incoming search terms:
- can i just pull one radio out and put another in
- kenwood pullout car
- kenwood pullout
- are kenwwod pioneer wiring harnesses the same
- replacing wires in kenwood subwoofer
Related Posts
Tagged with: another • Kenwood • pull • replace • simply • stereo
Filed under: Kenwood Car Stereo
Like this post? Subscribe to my RSS feed and get loads more!
Ahhh… right, sounds like you know perfectly well that you cannot… Couldn’t think of anything better to ask???
Likely it’s more involved, but if you luck out the wiring harness will be the same. 15 minutes is a little optimistic for even a simple swap out.
yeah you should be able to do it fairly quick, if your replacing it with the same exact stereo and if they didn’t install a security latch
If it’s a Kenwood also and the plug on the back is the same as the older one, then yes. If not, you’ll have to disconnect all wires and wire up the new radio.
Good Luck!